Makes unfolding a 914 a lot easier The nature of the scissor lift puts all of the support back into the car once it is off the ground. Note in the pics the original door gap, and how the door has begun to droop, and once I ran the lift up, the gap opened back up and the door raised back into it's proper position. Measure everything and install bracing while in the air, dropped it down and all stayed in place
Attached image(s)
Millimeters matter!
Show us the bracing please!
I think it needs a little more, the stripes and the handle pocket looks a little low still but you can fix it with the brace. The lift does give a lot of help though. Maybe a poboy could use a long 4x4 on each side with a floor jack under each side and one at the front in the center to get the same results.
Excellent.
Maybe you should post this in the Homemade Tools thread. Not really a homemade tool but a way to use a tool meant to lift a car to use it for aligning a 914 chassis.
BTW, Nice looking car there. Love the yellow. I have a yellow 914 too except its got a outer coat of red on it.
I want one so bad, I looked at very nice used one 3 years ago for $600 should have jumped then.
Someday...
Just not having to bend down all the time
That's awesome!
Would love one. Can't even find one to rent around here. How much should I pay for a used one in good shape??
but look at the foot print, doesn't the support steel on the ground get in the way?
On mine and i think Scotty's one side is open.
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)