I need to weld up a low, rolling engine stand for my SBC350 and transaxle. I want to be able to roll it right under my car. Anyone out there have some pics of theirs?
Strong furnature dolly's work. I use the large one, then get wood and nail it to the furnature dolly so that the engine is level. This allows you to get a low profile jack under it if necessary. Oh and have the front motor mount already on the engine, not sure if that was obvious..)
Good luck!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)