could have sworn I heard there was a five lug conversion Q & A thread around but I can't find it...Anyone?
Never mind, I found it. I'm an idiot....
down and dirty, tap and thread four extra holes into the front rotors and screw in five studs per side, remove the rear hubs and drill four holes weld in four extra bosses press in five 904 studs and buy two rear 914-6 rotors. Then install everything.
Thanks to my buddy craig and the use of the lift!!
Attached thumbnail(s)
Before:
After:
this one
http://www.914world.com/bbs2/index.php?showtopic=105728#
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)