Printable Version of Topic

Posted by: pete Sep 20 2010, 07:32 AM

Can I keep the original battery tray where it was for a V8 Conversion? I have a new one to weld in but would rather weld it in first before test fitting the engine.

Posted by: sean_v8_914 Sep 20 2010, 07:35 AM

yes. one of my V8s has teh OG tray location

Posted by: sean_v8_914 Sep 20 2010, 07:39 AM

from AZ with love


Attached image(s)

Posted by: pete Sep 20 2010, 07:43 AM

Very nice clean set up you have there Sean. Thanks for the quick response!

Posted by: sean_v8_914 Sep 20 2010, 07:49 AM

belongs to Guy in tucson

Posted by: computers4kids Sep 20 2010, 08:14 AM

Pete,
You might find answers to some of your questions by looking on the SBC link in my signature. Typical Renegade install.
Mark

Posted by: pete Sep 20 2010, 08:30 AM

Thanks Mark. That's a great thread. One quick question you might have the answer to, my Renegade engine bracket has two small tubes where it attaches to the SBC. One seems to be welded in the center of the vertical support. The other tube seems to be offset a little. Its not centered. Is this normal and am I suppose to orient the bracket where the offset mount tube is on the left or right side of the engine?

Posted by: type47fan Sep 20 2010, 03:51 PM

Hi Pete,

Jumping in here, I looked at my Renegade engine mount and the tubes you've mentioned are both centered and in line with each other, no offset. My mount is from 2007.

Thanks,