Looking for about a four to half dozen voltage readings to a dash gauge, (super secret project!!! )would prefere to have a gauge that displays four or more readings at once (0-18 volt DC range) or fit in a gauge "can" big enough to incorporate a selector switch in order to select which volt(s) reading is displayed.
any suggestions on sources???? Most all i see on the internet is single readout volt meters . Does anyone know of a multi-readout gague or one that can have selectable inputs?
\
We want this to look good as a dash top mounted single 'can'.m(big as it may have to be) We dont want 4- to 6 individual gauges, as constant monitoring is not needed of them all use of a selctor switch is possible. ideas anyone ???
thanks
Omega has them, but pretty$$, for a cheap solution, buy 4 meters from H/F at about 2.99 each and them up to fit where you need them. All you would need then is a 5 volt power regulator from radio shack for about 2 bucks. ( unless you want battery powered)
Here you go. But don't stay in the "candy store" too long. It gets expensive.
http://www.aircraftspruce.com/catalog/inpages/tlvoltamp.php
How about an LCD display. Then you can make it say anything? If the "Brain" is too big for a 2 inch housing, make it remote.
Pretty easy to do as a custom gauge, just depends how much you are looking to spend.
Search digikey.com
"Martel Electronics" has a thin 2 wire voltmeter, about .8 inch by 1.5 inch x .5 inch
and plenty of miniature rotary switches to vary inputs. I used a "Grayhill" brand.
I only used 4 poles I think it had 10.
Regards, Skip
Look at dakota digital or one of the other ebay all in one gauges for motorcycles.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)