I've got a tear in the side of an otherwise perfect seat that needs repair. I see vinyl repair kits all over the place and if they actually work they seem to be the ticket.
Has anybody done a DIY repair and how did it come out? Any tips? Thanks.
Tom
I've worked with the liquid filled that you heat with a texture pad to cure and they are a pain in the ass. Even a small are is hard to do and make it look right. For an area the size of yours, I'd have the panel replaced by a pro
I have used this:
With really good results on small to med tears and holes. You just have to take your time and fill with a small amount and build on it. Let the heat tool do it's job and not press down to much. I have done repairs on my car that my friends and wife can't tell there was ever a tear in the seat.
However I agree, with a area that size it would be hard to heat up an area that size evenly enough for it to turn out well with out being able to see the edges of the repair.
Did my back pad. May get better, but will not go away. The little heat stamp they give you is a joke, I used a model airplane iron on mine.
I bought a brand new backpad from Porsche. I had to rebuild the damn thing because it was so poorly made. What an idiot.
My experience...frustrating. You can make it look nice if you take your time and are super meticulous, but the 30+ year old vinyl flexes differently than the new material. After a few hops down on the seat and a few afternoons in the sun, the cracks will be back. Certainly the cheapest option though.
Has anyone tried this on a dash?
In my case perfect except for one small crack in the usual spot.
Black electrical tape works for the time being...
Thanks for all the replies, good info from all sides of the issue. Well, I ended up going with the Permatex kit simply because it was cheap and quick and if it didn't work I always have the upholsterer to fall back on. After several attempts that didn't work so well, my final attempt looks like this:
The good:
* It looks a whole lot better than it was.
* The repair will be on the interior side of the driver's seat, where it will not be subject to a lot of flex or scuffing.
* The repair is surprisingly strong. It's slightly stiffer than the surrounding vinyl but I can press real hard on the repair with my thumb with no sign of it cracking or lifting.
* Did I mention that it looks a whole lot better than it did before?
The not-so-good:
* It's very hard to keep the repair from creating a raised area around the patch.
* None of the grain textures they give you really quite match the original. I tried making my own out of a patch of vinyl I cut off the bottom of the seat but it tended to not release from the patch, even when I coated it with PAM.
+ The repair is shinier than the surrounding vinyl. I partially fixed this by spraying the area with SEM black upholstery/carpet dye, let it dry and buffed it out. Pretty close match.
* I don't know how it will age. I think it will age well, but time will tell.
If I were to do it again I'd cut the entire area out and cut a patch to fit from excess material at the bottom of the seat and trim it for a very close fit. This way, all you'd have to repair is the joint between patch and original, Since it would be a very small area the grain pattern would not be an issue. Also, by giving yourself a little more room to insert backing material you can get a very good bond with the original material. I think you could actually make a 95% invisible repair this way. On the downside, you have to make that cut.
All in all, I'm happy with the repair for a DD. It's cheap and fast and nothing says I can't take it to a pro later on.
Tom
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)