I have put almost everything back together on my 2.0 . I replaced all the fuel lines and vaccum hoses today and Was going to put the injectors in. But i wanted to know if there is a way to test them to make sure that they still function. There is no corrosion on the Injectors that i can see and they have been in a ziplock bag for the last 10 years. But i would rather know now if they are bad then have to find out when im trying to start her up on saturday. Does anyone know of a way to test them besides an Ohm test?
The machine was about $8000.00 to clean, test and calibrate them.
I would do the glass jar thing - hook up the system, but don't install the injectors into the runners. Put them in individual glass jars and while cranking the engine, observe the fuel spray pattern at the tip - Might help to have a second person to crank the engine.
Just a thought..................,
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)