Hi, I'm a 928 guy who has been planning to get a 914, but now it looks like we are moving next year so I'll likely hold off till then.
The reason I'm posting is that a while back I bought a bunch of 928 parts from this guy who also had some 914 parts; I bought it all planning on having spare for the future 914, I don't really want to haul any extra parts to the new home so I need to try to sell the extras but don't know a lot about the 914 parts.
1st is a side shift transaxle; is there a reference where I can match the numbers to the rear and/or gear ratios?
2nd is a pair of axles, the guy I got them from said they were HD axles for the 914 (definatly not 928 units); is there some reference for these? I guess I would need to know length from the outsides of the CV joint and diameter of the axle to ID it a2 a HD unit?
I also got some new carpet parts plus a yard of matching bulk carpet plus a yard of vinyl, and I think theres a few emblems and such; I'm planning on posting this stuff in the classifieds once I figure out what it all is.
shoot a couple of pictures and post them here.
i'm sure we can help you figure out what you have,
Andy
A little more info:
Axles: 26mm dia.; ~41-42 cm shaft length; ~37-38 length between outer edges of CV joints with joints pushed back; 2 10mm roll pins on each end; the do match up to the drive flanges in the trans.
Trans: PN 914.301.302.00 on rear cover; PN 914.303.127.01 on ear over shifter; HA 23 02 3 stamped along bottom rib of trans.
If I'm planning on gettin a 914 next year anyhow, should I be hanging on to this stuff?? I know for my '79 928 I'd love to have an extra tranaxle around for rebuilding since they(and mine) have synchro problems.
I can get a couple pics up later today also.
Keep it all. You will need it sooner or later.
WELCOME
B
Thanks for the welcome, this sounds like proper 914 parts then?
Here's a pic from inside the toolshed; can add better ones later. (928 has it hemmed in with dead battery...again)
Attached image(s)
Yep, just standard 914 side-shift trans and axles - no HD about them (nor does any HD - factory - of those parts exist).
Welcome to the Club 928er!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)