I got these, rebuilt by eric shea, from a member on the site here.
Went to put them on tonight and realized they look a little different than the ones that are on there now. Will they work ok or do I need different ones?
They look like 911/914-6 front calipers because of the spacer. They will not work if you have stock suspension.
Thse look like M calipers ( 3.0 in bolt spacing )that were used on 69-73 911 , 914-6 , note where the bleeder is on both to make sure you got left and right. They do look nice .
Jack / Jaxdream
to use those you will need a pair for "magical mythical Billet 4 bolt front hubs"
And then a pair of SC front rotors.
Or you need to change to early 911 front struts/hubs (5 lug conversion)
Depending on what you paid , you might trade for same condition 914 front calipers or rear for that matter . To use them will take more $$$$.
Good Luck
Jack / Jaxdream
M-Calipers for sure.
DanT nailed it. The "ClubHub" would be the only way. There was a guy making them "Mark" something. Nice guy in the LA area I believe.
-or-
I have a set of struts and 5-lug hubs... but then you're on a slippery slope.
I have a set of struts and 5-lug hubs... but then you're on a slippery slope.
That's how it all starts..... welcome to the 914 world
these http://www.bradrobertsag.com/product/4-LUGBILLETHUBS/9144-Front-Seat-4-Lug-Billet-Hubs-with-rotors-bearings-seals.html
will work with your calipers...
not a bad price for hubs, rotors, seals and bearings.
I ran them on my last car with M calipers. Also ran the stock 914 fronts in the rear (not suggested for the inexperienced in brake biasing )
Attached image(s)
That is a good price for that set-up complete.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)