I need someone in So Cal that has a Dyno and knows the SDS FI system to dial in my car so I dont have to guess
yes I need a chassis dyno
Try Craig at SimTecMotorsports.com. He uses SDS in many custom aplications for all different kinds of cars. He has a DynoPak chassis dyno and is located in Santa Clarita.
Are you having problems?
I've tuned several SDS systems and as long as I've had a wide band it's never taken me more than a few hours (last one about 20-30 minutes max.) just driving around on back roads. Often the factory mapping from SDS was about 80%+ dead on.
I use my modified ashtray mount so that I can program "heads up" on a 914.
It runs under full power but seems a little rich on even throttle. I would like someone to check the installation to make sure it correct as we hand no experience before hand
What injectors are you running and what is the average duty cycle?
What fuel pressure are you running?
Is this a fuel only or a crankfire system.
What are the specs on the engine.
If you have your map written down post it or send it to me in a PM (or PM me for my email address).
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)