Turn signals worked fine before I took out the fuel injection wires. Did they run through the CPU. Can anyone tell me how to get them back? The only mods to the wiring I made was I added a ground to the relay board at the top left terminal Where the fi harness was plugged in.
......you might have done this ?.....check your fuses out....
Did you disconnect the ground under the relay board?
The radio has its own wire and it still won't come on? That's a very bad sign. Time to double-check all of the connections to make sure wires are in the right places.
The wires for the taillight harness don't go to the relay board, they go up to the dash.
Check the fuses in the main fuse panel; they can pop and still look OK until you take them out. (Or sometimes spin them in place.)
--DD
The old ceramic or plastic type open fuses suck.
I drove 35 miles with the engine intermittently shutting off ... thought I had a loose wire to the coil or something. Couldn't find any bad wiring, but I did make it home.
I got up the next morning and the car wouldn't start
When I got around to checking fuses, found this one (looking intact) on the relay board in the engine compartment. The tit fell off after I removed it.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)