Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ ouch!!!

Posted by: bernbomb914 May 12 2004, 05:58 PM

Just finished the trans rebuild and low and behold it fell off the table. broke the bell housing. are there any cases in my area? and it looked so nice.

Bernie

Posted by: SLITS May 12 2004, 06:00 PM

Ah you North County Boys are always dropping something. I'll PM you where you can pick one up close to you.

Posted by: bernbomb914 May 12 2004, 06:52 PM

Thanks to ron I will pick up a case tomorrow morning. I thank him for his quick response.

Bernie

Posted by: Bruce Allert May 12 2004, 06:59 PM

At 4:15 today I was picking my tranny up off the cart to carry it over to the car for install. as I was walking I had to push a piece of 2x12 out of the way & thought "all I need is to drop this suck'a"! Hope I din't jinx ya Bernie. Sorry for your bad luck, man

BTW... slid mine in in 20 minutes. Jes'gotta hook evrythin up & see how the new clutch feels

......b

Posted by: bernbomb914 May 12 2004, 07:20 PM

so It was your fault?

Bernie

Posted by: Brad Roberts May 12 2004, 07:24 PM

Bern,

do me a favor and check the pinion bearing race. Stick your hand down inside the race and try to rotate the race. It is the larger of the two races that sit down inside the case. If the race moves... the case is worn out.

B

Posted by: bernbomb914 May 12 2004, 11:24 PM

Brad I will check the case I am getting from slits before putting any work in it

Thanks

Bernie