Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ ring & pinion mesh

Posted by: Chris914n6 May 22 2004, 01:00 PM

inside high, outside low.
At .2mm spacer gap.

Attached image(s)

Posted by: Chris914n6 May 22 2004, 01:01 PM

asfd

Attached image(s)

Posted by: KenH May 22 2004, 08:27 PM

Ideally the it should show contact in the middle section of the teeth.

I would try to move it a bit closer.

Do not forget to check the Diff. Cover pre-load dimension.

Ken