Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ Quick Question

Posted by: kconway May 15 2011, 02:19 PM

Is there a correct way to remove the fan support on the engine shelf? Did you just cut it off and grind it down or is there a way to remove the whole thing? Is there spot welds I should be grinding on? I don't see any?

Kev

Attached Image

Posted by: detoxcowboy May 16 2011, 09:40 AM

go easy so you do not leave a hoel,, that is all.

Posted by: sean_v8_914 May 16 2011, 09:54 AM

cut off bracket. drill spot welds on mounting flanges

Posted by: nathansnathan May 16 2011, 10:12 AM

If you don't need to save what you're taking off, it's better to grind the spot welds than to drill I've found drilling will inevitably go through the part it's welded to to some extent (or all the way), spot weld drill bit or not.