Can someone post a picture of the locations of the rear sway bar mounts that I need to weld in? Anyone have any measurements?
-Britain
Britain, the Bird Board is where I got enough info to install mine. The pics show various indentations where the brackets go. Wasn't too hard to do either!
http://www.pelicanparts.com/techarticles/914_rear_sway/914_rear_sway.htm
.........b
I will check it out...thanks.
-Britain
sklein did this a couple of weekes ago - i advised against welding while lying down...
I think if you were to stitch it, you may not get burnt that bad.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)