Printable Version of Topic

Posted by: TorqueJunkie Jun 19 2011, 08:34 PM

I am looking for the part number for the rubber grommet that goes into the factory sheet metal hole (about 1.5 inch hole or so) That the starter cable goes through. Looked in factory diagrams but cant find it. Anyone know what part # it is?

Posted by: tomeric914 Jun 20 2011, 07:07 AM

I used a Ford Chrysler valve cover breather PCV grommet available in the HELP! section of my FLAPS. Perfect fit.

Posted by: TorqueJunkie Jun 20 2011, 08:05 AM

ok will go to autozone and see if they have anything like that there in the section. Thanks.

Anyone have the factory number just in case?

Posted by: Bee Jay Jun 20 2011, 10:23 AM

Isn't that hole for the throttle linkage/rod thingie?
Bee Jay
My bad, the throttle hole is on the other side.
Bee Jay

Posted by: tomeric914 Jun 20 2011, 11:33 AM

If you don't find it or can wait, drop me a PM and I'll get the part number off the extra one I have.

Posted by: Cap'n Krusty Jun 20 2011, 11:46 AM

It's probably sold with the harness, and may not be available separately.

The Cap'n

Posted by: Eric_Shea Jun 20 2011, 02:18 PM

Put the part # here so all can benifit.

Posted by: TorqueJunkie Jun 20 2011, 07:15 PM

Yes, could you please post the number...I might be sold with harness, but would like to check. Still looking... Thanks

Posted by: tomeric914 Jun 20 2011, 07:32 PM

HELP! part number 42344

It was a Chrysler PCV grommet. Available pretty much anywhere.

http://www.autozone.com/autozone/parts/Motormite-PCV-Valve-Grommet/_/N-8gd5a?counter=0&filterByKeyWord=42344&fromString=search&isSearchByPartNumber=true&itemIdentifier=102885_0_0_

Posted by: bdstone914 Jun 20 2011, 08:30 PM

Starter wire is part of the standard 914/6 harness correct? Ill look at the original 6 harness I have and see if it has it.