Posted by: veltror Jun 28 2011, 07:56 AM
I was wondering if the part where the left tornsion bar front, is mounted exists as a repair panel
http://www.914world.com/bbs2/index.php?s=&showtopic=84350&view=findpost&p=1039858
Can i use a 911 repir part if one exists? Now that we have delved into this, it looks a bit worse then i expected?
Any ideas?
Roman
Posted by: Bartlett 914 Jun 28 2011, 08:41 AM
QUOTE(veltror @ Jun 28 2011, 08:56 AM)
I was wondering if the part where the left tornsion bar front, is mounted exists as a repair panel
http://www.914world.com/bbs2/index.php?s=&showtopic=84350&view=findpost&p=1039858
Can i use a 911 repir part if one exists? Now that we have delved into this, it looks a bit worse then i expected?
Any ideas?
Roman
It may be available. If not, you can get one off a donor car. This may be the best way to go. There should be plenty around.
Posted by: r_towle Jun 28 2011, 09:44 AM
you will need a front trunk floor pan also.
I suggest you send that pic to restoration design to see if they can help you out.
Rich
Posted by: veltror Jun 28 2011, 12:05 PM
ta, I will do that lots of donor cars in the UK, err no....
Posted by: Garold Shaffer Jun 28 2011, 01:10 PM
QUOTE(veltror @ Jun 28 2011, 10:05 AM)
ta, I will do that lots of donor cars in the UK, err no....
While that maybe true in the UK, there are plenty here in the USA. I would contact restoration design like Rich said and / or post extactly the size of the section you need plus a little extra so it can be trimed to fit.
There is a guy on the Samba in FS section that is going to cut up and scrap a 914
see this http://www.thesamba.com/vw/classifieds/detail.php?id=1138205
Place a WTB add here, the club, and pelican.
Good luck. I give you credit for saving another 914
Posted by: mepstein Jun 28 2011, 01:23 PM
Recent post for cutting up a car - http://www.914world.com/bbs2/index.php?showtopic=131329&hl=