Can you help me figure out how these go in?
What kind of engine? FI?
I thought of DD's article on Pelican:
http://www.pelicanparts.com/techarticles/914_center_tunnel/911_center_tunnel.htm
The top plastic line is the feed line. The bottom plastic line the return from the Pressure Reg.
Pelican has a diagram with the routing as well. This should help with the plastic lines. The center line you see, goes to the cold start valve.
I am guessing you meant these.
-Rob
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)