Printable Version of Topic

Posted by: fastmover34 Aug 4 2011, 04:33 PM

Done

Posted by: Garold Shaffer Aug 4 2011, 05:05 PM

For the eyebrows just pull it out. You should be able to reuse the rubber tips.

Posted by: 76-914 Aug 4 2011, 05:36 PM

You should be able to cock it at an angle then pull it out. I think the spade connector is preventing you from getting it at the right angle to pull out. Also, IIRC it is partially accessible from the inside of the car from behind the speaker panel? Don't hold me to it. I get hit in the head alot.

Posted by: SirAndy Aug 4 2011, 05:46 PM

There's one angle where it will come out, you need to play with it a bit more. I forget which way. But they come out easy once you hit the right spot.


As for the eyebrows, you can just press the rubber plugs out.
DO NOT use bolts!

They are rubber for a reason. If you like your fingers still attached to your hands, you'll reinstall the rubber plugs ...

Posted by: markb Aug 4 2011, 05:51 PM

Posted by: SLITS Aug 4 2011, 05:58 PM

Youse guys forgot to tell anyone to pull the headlight relay prior to raising the headlight with the knob.

Yep, I said knob!

Posted by: toolguy Aug 4 2011, 07:19 PM

Push them through with a small screwdriver best to put a little rubber lube on them first as there are another of the things you can't get anymore. . . .The reason they are rubber in the first place is so the smile will move if something {Like your finger] get caught when the headlight goes down. . . if you break them you suckin bad. . the two from the inside trunk are required. . you can use a piece of straight fuel line for the inner fender well one. . . of if you dont' care if it looks original you can use rubber grommets in their place.