I connected a booster charger to the cables on Sandy's Ravenna car tonight for the first time just to see how this would pan out. When I got the car there were no keys, the fuse panel was hanging down and the gauges were hanging out of the dash. The engine was out so there was no way to check to see what was working and what was fudged.
The engine is now installed, Jeff Bowlsby went through the engine harness and it checked out. I pulled the column and replaced the switch and wiper switch.
Everything on the relay board looked fine and is plugged in. Here's what happened when I turned the key on:
MPS is buzzing loudly
The Generator light on the combo gauge is flashing
the tach in bouncing around 3000 rpm's.
Now there is no battery in the car just a booster charger but I don't understand the wierdness with the dash and specially the MPS.
All wild suggestions welcome.
I would check and clean every ground in the car first. Wierd things happen with bad grounds. Then I would double check the gauge cluster and relay board wiring.
I suspect that the booster chargers output is not perfectly DC there is possibly some AC in i making things jump around. Check with a battery instead.
/Lars S
Check the ground above the fuse panel too. Electricity takes the path of least resistance. Even if that is through another circuit. Current will look for a "more negative" source even if that is not a true ground.
check that your relay board ground (underneath it on the inner fender) is good.
Check that you have power at the starter when the key is in the start position...
Ed uses a little trick.
Put it in neutral and use a quarter to jump from the large positive lead on the starter to the little spade bit on the starter (where the yellow wire plugs in).
A quarter fits nicely.
There are three (I think) little red wires on the positive batter terminal along with the large starter wire.
Red feeds the ignition switch....yellow comes back down to the starter from the ignition switch.
You can see then on top of the tunnel near the shifter.
Put a pin through the yellow on and put a volt meter on the pin and ground...turn key to start position...should light up (or use a test light)
Voltage regulator looks like a pack of cigs on the relay board...
Pull it out (its got a screw) and clean up all the crap, then put it back in....shake it around gently while you have it out (ask Ed)
Check all your fuses, you may have blown one or two without the battery in place.
RIch
You probably have the battery and brake warning light wires switched around. Easy to do, results in a battery light that flashes when the handbrake handle is pulled up.
I've never heard an MPS buzzing! That's very weird indeed!!
--DD
ac, dc, different things.
Need a battery to run a car, it smooths out the wavelength.
Rich
Doesn't electric things go wacky when the alien ship is nearby?
Sorry, couldn't pass that up...
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)