Can you redrill mounting holes on wheels that are normally 12mm? I need to have 14mm holes, for The Van.
Hi Dave, Can't answer your question. But I did want to say Hi Show us the wheels you want to re-drill.
It can be done. I know a good machine shop over in Spokane that has a lot of experience doing this. Experience doing this is important, in my opinion. They measure the angle of the lug nuts that will be used, and then machine the wheels to match the new lug nuts. I don't know the local machine shops, but with all the work that gets done in this area, I bet somebody has experience doing this. Call around.. call the older established machine shops. It shouldn't be too expensive.
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)