Where does the wire I have circled go? It wasn't attached to anything so I'm trying to figure out why it wasn't attached and where it should go.
Thanks
Kirk
Attached image(s)
I believe that goes to the cold start thermoswitch. Visible in this picture on the bottom left of the plenum. Just behind the coldstart valve itself.
http://www.914world.com/bbs2/index.php?act=Attach&type=post&id=269525
Only used in very cold weather - around freezing or in that neighbourhood.
AAR?
That looks like the cyl head temp sender wire. It should have a 1/4" male spade conn and a big rectangular plastic insulator on it.
I don't think so John/Mark. The CHT should be in the first cluster with #3 injector lead.
Jeff Bowlsby has done a great job documenting the harness
http://bowlsby.net/914/WiringHarnesses/HarnDia_FI_EA-EB.jpg
CHT is "E" and the thermoswitch is "K".
Interesting though that the CHT lead doesn't show in that picture. Maybe behind the harness itself
I have a plug for the CHT, that is what has me puzzled. Doesn't the CHT take two wires? This is a single. I'll go to Jeff site and check it out.
Thanks
Kirk
single wire. return path is through engine ground. same thing for the thermo switch
Steve you got it! It is the Thermotime switch.
Thanks everyone.
Kirk
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)