I have been looking for a wrench to adjust my MPS. A "7mm Star" is called for. This is not Torx. I have looked and I cannot even properly identify what this form is. Does anyone have any information on what this is properly called and any sources for one? I really don't want to have to make one.
If it's not a torx, then maybe it's a triple square or a "Ribe". I think Ribe fasteners are used on the brake calipers so maybe also on the MPS...
I think I made one out of a piece of square axle key stock from the hardware store....
Geoff has one he made, maybe he will post a picture.
Rich
They're available, try most FLAPS, ask for a 7 mm star bit.
I found a set of 5 bits for about $12.
I gave up and made one. The tool was described as "Star" but I think it isn't a Star. I tried everything and nothing fit. I spent about 3 times more time looking than making. I made this out of solid titanium.........Was that overkill?
Attached image(s)
Hey Mark that's nice! If you decide to make a couple more I'll buy one!
Me too!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)