I have an engine lid hinge bracket that I need to remove and weld a new one on. If I have the rear window still in the car, how do I hold the bracket in place to weld it? I do have the engine out of the car, should I bolt the engine lid to the existing one and the new one, then have someone hold the engine lid in place while I weld?
If you have any pics I would appreciate them.
I removed the rear window to do mine. It took like 5 minutes to remove the window since the butyl tape was only like a year old. Once removed, I used a deep 2" c-clamp to hold the new bracket very tight against the firewall. Tack it in place then remove clamp and attach the lid to check the fit. If it's good, clamp it tight again and finish the welding.
You could also use one of the magnetic "clamps" to hold it on w/o removing the rear window first.
Thanks guys for the advise. Now, if I can only find that hinge I bought from PP 18 months ago I'll install this weekend.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)