I nred to pull off the cam sprocket. I just need a crowsfoot
No. That's a big asses crows foot. Good luck
I have all the tools for this. The 46mm foot and the special socket. If no one local has it, I will let you borrow it.
not just any 46mm crows foot will work either
get one made for the porsche 911 motor job
I did buy one local thinking I could do the same as you
the thickness, and the angle of the local one I bought will not allow it to fit in there...
you need one specifically for 911 motors, or the same angle as one for 911 motors.
Let me know. I have the Porsche one.
Just buy one. They sell like hot cakes on Pelican after you're done with it.
I bought all the crap....er stuff....12-13 years ago then sold all last year for about what I paid for them.....engine yoke, dial indicators & all.
DIY is gud.....cheep too.
I have one and the cam holder tool
... and it is in SEATTLE!
Eddie to the rescue
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)