First scan of the 914 shell didn’t turn out so well. See how many holes are in it? Ouch!
A nice ‘flat grey’ primer should do the trick.
And it seems to not reflect the lasers as much.
The first cut paths were a little bit slow and poorly drawn:
The new ‘back and forth’ code seems to work much better:
All 13 cut out:
The RC wheels code seemed to transfer nicely to the router table.
Applying some shiny surface/clear coat/stain:
All 13 cars and 7 appreciation gifts on my ‘portable workbench’:
Finished and with vinyl:
To dispell any rumors or misconceptions that might exist or be caused to exist because of the following picture; This was an 'extra' that I made for Shoe because he worked his ass off to put together MUSR12. He had no idea it was in the box. The plan was to send it in a separate box, but the guy shipping the boxes was having problems with his TPS reports...
Cars with vinyl:
Thanks for sharing the process.
These plaques turned out GREAT and I ended up with two of 'em
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)