This is my caster/camber box thread.......................
Picture before.......
SteveSr
Attached image(s)
Top is out...............
Attached image(s)
pieces ready to go in......
Attached image(s)
One more.....
Attached image(s)
Hey Steve,
For better viewing and following your progress, I merged the threads into one
Please post your new pics etc. in this thread and don't start a new one for each pic
(click the "add reply" button and NOT the "new topic")
Looks good... but why did you drill out all the spotwelds?
cheers,
Jeroen
Thanks Jeroen,I thought of just adding a reply after I had them all posted..DUH.....
I thought at first I would remove the whole top then realised I could just cut the top out.I will have to re- the spotwelds back up. I won't make that mistake on the other side. I'll add new pics as I go.
SteveSr
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)