what are the pro's and con's to a dydraulic clutch versus a cable in a 915 in our cars?
Thanks,
Bill P.
If you have the ability to run a stock pedal assembly.... run a cable. If you have bottom swing or top swing Tiltons.. then you have to run a hdy. clutch.
I'm not convinced hyd is the way to go. It works well when you have a Monster pressure plate and need less pedal effort.. but if I had my choice... cable. Easier to deal with at the track if something goes wrong.
B
Here is the hydraulic TO bearing...WEVO set-up on the tube car. If you go this route, you have to fab a stop plate behind the pedal because the travel is only about 2 inches to engage/disengage. This unit is basically on/off, takes some time to get used to.
-Britain
Attached thumbnail(s)
Save the money and run a stock Throwout bearing. The main reason that is in place: the WEVO 5.5 clutch setup and the car doesnt have a clutch tube for a cable... it was already Hyd.
B
You mean this clutch set-up...this is one bad-ass Mo-fo. Talk about throttle response.
-Britain
Attached thumbnail(s)
My thoughts are the same...I would like to just run a cable for simplicity...I'm going to run a "stock" type pressure plate and certerforce clutch....in fact...it's sitting here next to me....it sure is pretty
I was just checking my thinking....
B,
How long would it take to plug my drivetrain into the car if I give it to you/HPH to do? I'm talking drivetrain and full oil cooler assembly including hoses....I've got all of the parts on my shelf already....
I need ballpark hours...I know the rates....
Spreadsheet is calculating....
Bill P.
I would do it after hours to help offset the cost. Your looking at 10-12 hours. The fuel pump..high pressure lines..wiring/mounting..
I would work something out with you no matter which direction you take.
B
In this case.. Britain didnt know exactly what he was talking about... the Tilton 5.5 clutch is the ON/OFF switch not the throwout bearing setup. This particular unit (nobody else makes one for the Porsches besides WEVO) only works with push center pressure plates. WEVO also has one for the 901 gearbox. This one is in a 915.
B
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)