Printable Version of Topic

Posted by: jmargush Jan 7 2012, 02:34 PM

Is there a trick to getting the clutch retaining bolts out? they sit right against the ring gear on the flywheel preventing a socket from sliding on. and I can seem to get a good grip with an open end.

Posted by: nathansnathan Jan 7 2012, 02:44 PM

I just experienced this in the engine of my parts car. Someone used the wrong bolts and the heads were super close to the edge of the flywheel. There was no 'good way' but I managed with a wrench and even a 1/4" ratchet.

The right bolts are supposed to be smaller wrench size with a serrated flange.

Posted by: reharvey Jan 7 2012, 02:56 PM

QUOTE(jmargush @ Jan 7 2012, 03:34 PM)

Posted by: jmargush Jan 7 2012, 03:48 PM

I got them out but it wasn't pretty. I compared them to my 1.8 engine that still has the clutch on it and those bolts sit higher that the ring gear almost like the pressure plate on the 2.0 I am tearing down is thinner or the flywheels are different and the 2.0 has a deeper recess inside the flywheel.

Posted by: rjames Jan 7 2012, 05:13 PM

Hmm, I was able to get a craftsman socket on mine when I replaced the clutch & flywheel on my 75 2.0 recently.

Posted by: A&PGirl Jan 9 2012, 05:17 PM

The 1.7/1.8 Clutches use a shorter length bolt than the 2.0.

The -6 Clutches use the same length bolt as the 1.7/1.8.

They all should have washers underneath the head.

The -6 and -4's list the same p/n for the clutch & pressure plate.

Posted by: SirAndy Jan 9 2012, 05:48 PM

QUOTE(reharvey @ Jan 7 2012, 12:56 PM)

You need a thin wall socket. I make my own by grinding down the outside until it fits over the bolt. Yeah--that's low tech but it works for me. Ray