Look what FexEx just delivered, trunk hinge w/bolt, battery tray and stand, right engine sheld and right rear suspension ear. 1 of 5
Attached image(s)
Now, I need help installing the suspension ear.
This is what I have to replace.
Inside shot 2 of 5
Attached image(s)
Outside shot 3 of 5
Attached image(s)
Top inside shot 4 of 5
Attached image(s)
Underneath shot 5 of 5
Attached image(s)
Now, I was thinking of cutting the engine shelf on either side of the suspension ear, then drill out the spot-welds.
Then I was going to drill out the spot-welds on the ear.
My biggest concern is the piece that attaches to the ear on the outside, see underneath shot. What should I do here, grind down the patch work, then post the evidence?
Also, this ear appears to be very solidly attached to the car, should I repair now or wait?
Finally, what dimensions should I measure before removal?
Has anyone, besides Brad, completed this repair successfully?
check this thread...
http://www.914world.com/bbs2/index.php?act=ST&f=2&t=16191
cheers,
Jeroen
Thanks Ya-roon, I'm definately following that thread.... Great stuff for me to use as reference for my next project.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)