Mark Henry made this great custom mount for running external oil cooling, filter on your 914, however I had a problem making a hose assembly that would clear the bolt (red arrow).
One solution I had was extending the plate port with a 2" nipple and a female coupler. Problem with that was that there was about 4.5" of unsupported brass hanging off the side of the motor, with extreme motor vibration, not a good situation.
Then it dawned on me that my local hose fitting shop could make up a hose using crimp on ends. These ends take up almost 0 space and fit perfectly. Also, having the hose extensions from the ports on the motor will make installing and removing the motor much easier.
Next hurtle...
dr
Attached thumbnail(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)