Got these used off a guy here (i think, maybe PP classifieds) just got them today so im postin pics.. any advice in removing old ones from my car and installing these puppies would be appreciated
Attached image(s)
asdf
Attached image(s)
adsf
Attached image(s)
the under side
Attached image(s)
Check the mounting tabs/hoops to make sure the welds aren't cracking. They look awesome.
I've read here somewhere that it's a good idea to take a large (long) file, and square the tops of the inlets even with each other to get a good seal at the exhaust ports. Make sure that the old copper gaskets were removed from the exhaust port. And I haven't tried it yet, but I hear that using a small amount of red RTV to hold the new copper gaskets in place while installing the new HE's works pretty well. I'll be doing the same thing in a week or so. Also, you'll want to soak the hell out of the exhaust studs and nuts with PB Blaster or something similar to ease removal of the rusty-ass nuts.
P.S. - nice clean set of HE's you've got there!
As requested
The beautiful scenery of Lake of the Ozarks "Party Cove"
thats the one....
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)