OK, I have new pieces to weld to the car. They are attached by spot-welds.
What is the optimum hole size to drill for the holes?
Please select from 1/4", 7/16", 3/8"
Suspension pieces -
Body pieces -
And yes, I'm using a MIG welder and will use the rossette method.
They make an air tool that punches the holes. The size of the die on the tool is 3/16".
Attached image(s)
Yea 3/16"
1/4"+ is to big
that air punch/crimper is the shizzle.
make sure you get "tight iron" ( LOL I work with ironworkers... that means "fits well") otherwise youll likely have some nasty looking welds ... lots of vise grips... and weld from the bottom up
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)