The union between the hard pipe return tube and the rubber hose to the oil tank will not release. Is that thread a normal thread, clockwise rotation is tightening?
I have soaked it with pb blaster and sili kroil with no luck. My next step is to cut the rubber hose.
Any ideas to save cutting the hose?
Thanks
Gene
heat focused on the metal fittings
try 55 ...there tight
I found that using two wrenches and squeezing them together would give me double leverage!
big wrenches with long handle plus a third hand to keep the heat on
did ya get it ??? i wouldnt use heat ..but thats just me
MikeC
Nothing works so far. A friend recommended Sili Kroil used by aircraft mechanics, nothing so far.
I'll have to disconnect the hose at the tank to save the hose. I'll remove the tank.
Thanks
Gene
bummer
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)