Hello all,
Got the car back together enough to enjoy for the time being. I installed what seat belt bolts I had left from the PO. I unfortunately don't have the "over the shoulder" belts, only lap belts at the moment. Is there any way to find out the bolt sizes and spacers necessary for each bolt? For right now again, I only have the four lower ones near the floor. I can post some pics in a bit if necessary. On that note, does anyone have any input on what a decent used set of full retracting belts should cost? Thanks!
The bolts are not a metric size.
Some kind of fine thread SAE bolt is used.
Don't ask me why, maybe some DOT regulation.
John
Here is the thread
http://www.914world.com/bbs2/index.php?showtopic=88886&hl=seatbelt++retractor
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)