My 75 GT clone has a 3.0 with Weber carb's and up until today I had K&N billet aluminum air filter housings. Back when I was collecting parts for the conversion I came across a OEM Porsche air filter housing that I believe was from a 911. It is all metal. Today I decided to install the OEM filter housing. It fit fine in regards to lining up with the carb's but it was too tall in a few areas. I had to dimple the housing in some areas with a hammer for clearance to the engine lid. I eventually got it to fit and the lid closes. Does the 914/6 air filter housing have a lower profile ?
Yes it is Plastic & is lower in that area
If you have PMO manifolds they are taller also.
I have a plastic housing with no snorkel. PM me if you're interested.
But, as the thread bears out, you need both generally... Shorter manifolds and the lower profile housing. Measure yours and I can measure this one. Maybe we can see how close we can get it. Your snorkel should fit.
Does anyone have a source on the clips that hold the top portion of the plastic air cleaner to the lower portion /carbs??
PN: P 911 108 167 00 ??
Thx for any insight
Mike
914-6 project
Sorry for the hi-jack, but how much taller are PMO manifolds?
This is what I have, but I need an aluminum plate to complete my air cleaners.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)