Got the outside of the thing looking pretty good. I guess being caked with oil keeps it from rusting.
But the inside has sludge and stuff inside that I can't get to. Brake cleaned as much as I could.
Hate the idea of putting that thing with all that crap still in it on top of a new motor.
I want to make a nice aluminum filler one day. This thing looks like it came off of an old tractor.
Anyone BTDT?
You gotta love that thing- heh!
There must have been a better way to do that filler. Whats even worse is that the funky little bail-wire used to hold it down won't keep oil from splattering all over your nice clean engine.
A temp solution is to use your favorite RTV type gasket sealer on both sides of the filler gasket. Also make sure the cap has its seal in place.
Enjoy!
I would think the best way to stop that funky oil filler from leaking would be to convert to a 914-6. Pesky oil filler leaks will be a thing of the past.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)