I go to install the door to my glove box. The Porsche manual says there should be a bushing or spacer. Does anyone have a pic of this spacer? I could look through my parts box to see if I have one, if not can one be made
no pic, but they are round, plastic and pretty big in dia. (like, at least 1")
Andy
The bushing is plastic about 1" in diameter with a small protrusion around the hole, where it acts as a guide.
Muffler bearings also worK!
not quite a good pic, but yea it was taken at night...so yea....the PO had a sense of humor
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)