Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Removing throw out bearing pivot stud
Posted by: chris914 Oct 10 2004, 11:58 PM
Whats the best way to removing the throw out bearing pivot stud? It's the one with the ball end screwed into the transaxle.
Posted by: sj914 Oct 11 2004, 01:12 AM
Unscrew it. It's not that hard.
Posted by: Bleyseng Oct 11 2004, 07:11 AM
use a wrench to unscrew it.
Geoff 
Posted by: sgomes Oct 11 2004, 07:32 AM
I use a 
and then put it back with 
Posted by: BIGKAT_83 Oct 11 2004, 07:34 AM
QUOTE(chris914 @ Oct 10 2004, 09:58 PM)
Whats the best way to removing the throw out bearing pivot stud? It's the one with the ball end screwed into the transaxle.
Chris I used a 14mm 1/4 drive deepwell socket .
Posted by: SirAndy Oct 11 2004, 10:11 AM
as socket with a thin sidewall will do, you might need to grind it down a bit ...
Andy
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)