Is there a template, or measurement I could use to put timing marks on my fan itself?
I know about the one from pelican for the housing, but I would like one degree marks on the fan itself.
I am not certain I can accurately measure the diameter of the fan...hoping someone knows that number...I can do the math from there.
Rich
http://www.pelicanparts.com/techarticles/914_timing/914_timing.pdf is made to mark the fan itself.
Why would the diameter be hard to measure?
Either you need a very large set of calipers or something else as neat.
There is a large protrusion on the back that gets in the way for a simple ruler or tape measure.
Rich
The fan diameter I measured is 227mm. Circumference would be 713.234 mm. One degree would equal 1.9812 mm
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)