the only markings on it are Atz and 17 on the outside half with VW and 22 on the inside half. it has a banjo fitting on for the brake line connection.
k
Attached image(s)
It might look like a z Kevin, but I would bet it is an e. ATE is the manufacturer of lots of brake components.
That's an early 914 front caliper. Basically made off the same casting as the 911 rear calipers with the fluid inlet on the back and not the side and, with a 42mm piston vs the 38mm variety on the 911.
These have standard hex head M7 fasteners vs. the Rive versions on the 911 caliper.
They will only work with the early 914 rotor offset.
bummer. they wouldn't have fit in the boxes anyway. want em'? maybe good for the concurs folks.
k
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)