I just purchased a set of Fuchs 2.0L alloys to put on my 74 2.0L 914. I currently have the "Dan Gurney"
copy wheels on the car. Upon investigating, the wheels are held on by nuts instead of the long lug bolts
I've seen most cars use. Question: were the lug bolts stock with the 2.0L Fuchs alloys or did Porsche
use lug nuts and studs on some of these cars? I'm just a bit confused of which is proper and if it matters.
I haven't looked to see if I can possibly reuse the studs I have on the wheels now or not. I do know if I do that I'll need to get different lug nuts due to the ball end shape on the Fuchs. Thoughts??
I'll be doing this in just a few weeks, also. I have 2 cars w/ the Dan G's. One has the original lug bolts while the other has the A/M studs 'n caps. I alos have the original Fuch's lug bolts so I'll check the fit once I get my rims back from the polisher.
the longer one is for fuchs and the shorter one is for steel wheels.
these are ball type - not cone type.
Attached image(s)
I have Fuchs as well and my car was set up for autoX, this ia a great and costly modification (cuz the studs can cost $5 or $7 each); you now have studs like conventional cars; all you need now are regular steel lug nuts that are not closed on the end. if you don't want this set up, you could probably sell them to another member. just be careful and don't mess up the threads when you hammer the stud out. use a sacrificial lug nut and/or an impact hammer
The studs on the car now are the screw in type with the hex end not the press in studs. I'll have to see
if I can remove them. I only have 3 original lug bolts that came with the Fuchs I bought. I'll have to
get a set of lug bolts.....
I guess I have my work cut out for me. Thanks!
if your studs are in nice and solid - just get the right ball type nuts.
http://www.pmbperformance.com/page/page/1925563.htm
jim
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)