Alright guys so I pulled the motor a few weeks ago and went through it all and now I Have it installed again but the s.o.b. doesn't want to start. I have a new set of points and condenser(pertronix failed), cap and rotor, Plug wires, coil, and plugs. I was timing it yesterday and it just quit on me. Upon investigation I found the plugs aren't getting any power.
Any thoughts on what it could be out there??
Transmission ground strap? May be bad grounds. If your coil has power, you can "tap" a test light on the negative terminal and induce a spark. You will know if the coil and plugs work. If they do, your points need adjustment.
It's hooked up ok but it's very worn. Would that make a difference?
Yeah theyre(fuching autocorrect) opening and closing and gapped at .016
First make sure you are getting 12 volts to the coil with a meter or light tester. If no power, then you will have to trace the wires back to the relay board and ignition switch.
If you have power to the coil, remove the high voltage wire and lay it next to ground. Remove the negative wire to points and condenser, and tach wire. Now put a jumper from the negative side to hang loose. Turn on the power at the ignition switch and tap the jumper to ground. Getting a spark from the high voltage wire? If no, coil or high voltage wire is defective. If yes, you need to check out your points AND/or condenser.
Tom
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)