Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ Bearing sizes

Posted by: Headrage Oct 19 2004, 04:04 PM

Just talked to rimco and was told that my cases required an align bore and they are now .20 over. Crank just needed a polish. Does this mean I need to order .20 over main bearings?

Posted by: MattR Oct 19 2004, 04:33 PM

Yep. When rimco align bored my case, they had bearings in stock. I think they were Mahle.

Posted by: Cap'n Krusty Oct 19 2004, 04:45 PM

You need standard crank, 20 over on the case. BTW, I can't remember EVER seeing a T4 case that needed an align bore, including a couple of cars that were time trialing weekly for a couple of years. The Cap'n

Posted by: ArtechnikA Oct 19 2004, 04:50 PM

funny how sometimes cases sent to RIMCO for work wind up needing rare bearings only they seem to have in stock ...

Posted by: Joe Sharp Old Oct 19 2004, 07:14 PM

I've been using RIMCO sence the 70s and never had a problem with them.
Joe

Posted by: URY914 Oct 19 2004, 07:28 PM

I always heard that line boing a T-IV was very rarely needed, if ever.

Jake will jump on I'm sure.