Need advice on removing rollbar pad. I have removed the screws front and bottom but something seems to be holding it in place. Thanks.
That should be it. Make sure you have all of them out. I had a couple that were stuck in the pad and couldn't be drawn all the way out. So I had to pull and unscrew them at the same time. Sometimes they just get stuck.
Do you have the side bolsters out? I just installed one. I used a longer SS screw. It sure made it easier to put in.
Did you forget the two screws inside the latch opening?
They are very hard to get to!
Be patient...I learned the hard way and now I can't find one to replace it.
The screws can be a long way into the padding and the heads can work their way crooked. If you don't have the screws all out they are probably still attached tp something.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)