I need to replace my sway bar mount bushing in the rear. There is a lot of play and they are almost forty years old. The product note says to slit on one side to fit around bar. My question is this: Where should I slit for optimum fit and performance? Here is picture of sway bar mount bushing from Pelican Parts
I am also replacing my Rear Sway Bar Drop Link Bushings while I am down there.
Attached image(s)
One the horizontal side as pictured. . doesn't matter what side, as you can turn them around when you mount them. . just not on the top or bottom as they are thrust surfaces/ /
Here's a factory bushing (orange center section). You can see where they cut it:
Wow! Y'all are the greatest! Thanks a million.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)