My car was/is a non appearance group model and I am fitting TN4's and new grilles to the front here in the UK....
Does anyone have a diagram or pics of where the location of the fitting holes are for front fogs? Are they out of reach of a ratchet spanner?
There is a raised square in the front clip. The fog lights attach with a single bolt to the center of that - I would think the raised part would be there for non-appearance group, just not the hole in the middle of it.
here's some pics, best I've got, but you can see the "raised square" I mean anyway.
I think the part you ask about the ratchet access, it is a welded on nut? I can't remember. This pic shows it is a pain to get behind there if it is a nut, but I can't remember. You have to cut off your fender to get to it.
Cheers....
Mark drilled a hole and welded a flange nut into the center of that raised square to mount my Pilot lights in the factory position... Works like a charm
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)