Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ 914-6 Conversion Maintenance

Posted by: map Aug 22 2012, 05:38 PM

Thinking ahead to putting the drive train back in the car, a couple of questions come to mind.

1. With the pulley with the timing marks so close to the firewall, how will we set the timing?



2. In the future, how will we turn the engine if we want to adjust the valves with the engine still in the car?

Pieper

Posted by: SLITS Aug 22 2012, 05:45 PM

1.) Most? cut a hole in the firewall to access the distributor, see the timing marks and change the alt belt. Alternatively, you can mark the flywheel and cut a hole in the tin to see the marks at the parting line. When loosening or tightening the distributor bolt ... keep your thumb outta the fan!

2.) The firewall cutout will allow access to the crank pulley bolt and marks. You can turn the engine with a wrench, but seeing the marks is the problem. You can turn the engine and use the "backside" method as you can see the position of the lobes of the cam.

I tried a mirror for all the above, gave up and cut the hole. Oh, you fabricate a cover for the hole too!

Posted by: tomeric914 Aug 22 2012, 06:54 PM

QUOTE(map @ Aug 22 2012, 07:38 PM) *

2. In the future, how will we turn the engine if we want to adjust the valves with the engine still in the car?

Put the car in 5th, jack one side of the car up, rotate the wheel forward ONLY and use a mirror to check the timing marks.

Posted by: map Aug 23 2012, 02:24 PM

QUOTE(SLITS @ Aug 22 2012, 05:45 PM) *

Oh, you fabricate a cover for the hole too!


How'd you make the cover. Any pics?

Pieper

Posted by: brant Aug 23 2012, 02:44 PM

the cover can be nearly flat
they are fairly easy to fabricate
we made one from aluminum and it was also easy to roll 2 edges.

brant

Posted by: pcar916 Aug 23 2012, 03:04 PM

When my car was a 2.7L I used the flywheel and timed from the rear of the engine. The DME engine doesn't need it... obviously.

My access port is larger than most because I actually wanted not to be crowded by any operation... including a broken fanbelt. The cover was simply formed over the piece I cut out, but big enough to use Dzus fittings around the perimeter.

Below are two photos, one during the 2.7L to 3.6L conversion. The other is current.

Good luck

Attached Image

Attached Image

Posted by: map Aug 23 2012, 05:57 PM

Wow! Thanks for the pics.

Pieper

Posted by: majkos Aug 24 2012, 07:46 AM

idea.gif dry.gif beer3.gif popcorn[1].gif idea.gif evilgrin.gif

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)