Hi, I'm finally getting ready to put my engine and tranny back in the car and am just sourcing the final few parts and see the throw-out bearing is ridiculously over priced Is there any other options then the $150 route? I've already checked NAPA and they can't get one.
Thanks'
Jon
At this price they should be called throw-up bearings
No kidding... Have you replaced the clutch and pressure plate? If not, it may be worth the $$ now so you don't have to drop the tranny again later...
There is NO substitute. Man up and buy one.
The Cap'n
$128 shipped from AutohausAZ
I bought a new SPEC Stage 3 clutch kit and got a free one. Clutch kit only cost me $700...
Just bought one from Pelican a few weeks ago. I think it was $141.
Is the old one making noise or you are just wanting to renew it cause you have it tore apart?
I have a used one in good condition you can have cheap. Removed because converting to V8 and the KEP kit has a new one.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)