So I found two little pinholes on my gastank. the area that sits on the little shelf has rusted. a patch about the size of a dollar bill. so if I flush the tank with water and leave as much as I can in it at the time what are your collective thoughts on me welding (mig) a patch panel in? I also considered using JB weld to patch it but as we all know the rust will just keep on growing under there.
Acid dip it, get a tank coating kit that has rust neutralizer in it or get muiatic acid from a supply house. The acid will neutralize the rust. Then JB weld or solder to repair. I would never weld on a gas tank unless I was a certified welder with years of experience. If you do decide to weld, make sure to borrow some saftey gear from your local bomb squad.
I'd take it to a rad shop and have it boiled/cleaned/hot tanked to see if it is worth saving first. That way you will know it's safe to weld on. If they clean it and it has many pin holes, you could ask/look in the classifieds to see if you can get a replacement tank at a cheaper cost than the repair will run you.
The rest of the tank is rock solid. not a speck of rust anywhere else. I may neutralize and jb weld it. seems a helluva lot safer
Waste of time. Spend the bux, do it right, live to drive your car. JB wels isn;t up to the job. I have a neighbor without a brother and nephew as a result of a mistake welding a gas tank truck at his own professional welding shop. Any competent radiator shop can fix it for you. The Cap'n
Or better, get another tank. We don't like losing 914 guys!
I've heard of people converting them to fuel cells. Might be worth looking in to.
Fill it with some sort of fluid before welding... like gasoline or moonshine.
Just kidding
The oldest body shop in our town used to repair fuel tanks by gas brazing them.
They did it as follows: attach a rubber exhaust hose to an exhaust pipe of a running car and the other end to the fuel tank, let the car run for about a half hour or until the fuel tank was a little warm to the touch, braze the holes and let cool before disconnecting everything.
This was done outside of course, and they never lost any body men doing it.
I probably wouldn't do it this way though. The argon gas method is probably the best approach.
tanks are like a dime a dozen. cheap!. im sure you could get a good used tank for 50 shipped
Heck, I have a couple of spare good tanks... Not worth the danger IMHO!
I you MUST weld it yer self, http://www.914world.com/bbs2/index.php?act=ST&f=2&t=19368 thread from Geoff will help!
If you do decide to weld it, I agree with a previous post, fill it with water first. I have done 2 tanks this way. Not 914 tanks, but gas tanks. Otherwise, I would just find another used one. They don't damage often and should be plenty of them around.
I just read a mag this week where they said to rinse the tank first and then run exhaust fumes through it (like Perry states above). That should take care of any left over gas fumes
Then again better be safe than sorry. Not a thing I'd like to experiment with...
Send it to FuelSafe and have the conversion done. I've seen one up close and they are awesome. Not sure about the cost.....
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)